Edge

 

Edge - end face processing material.

The width of the edge must be greater than the thickness of the material. Usually the difference is 3 mm, but it depends on the production settings.

If the width is not correct, the system will display an error.

 

You can enter the edge parameters in the same way as the material parameters.

The edge has its own page (symbol "i").

The edge has a serial number, in the future it is used when typing detailing.

The edge can be replaced with another one. If you select another edge from the drop-down list, the system will replace the edge in all materials/parts on all sides where the current edge was selected.

 

Edge Page:

The values of the specified properties are pulled from the admin panel. The client can enter their own values. They directly affect the calculated amount of edge.

 

When you change material or edge properties on the order form, these changes are highlighted for production. If you entered the values manually, be prepared to return the order for revision by Production.